Calculate septic tank size, daily sewage flow, leach field square footage, trench length, and estimated installation cost based on bedrooms and soil type.
Primary sizing factor for most states
Used to calculate daily flow
From perc test or soil survey
YOUR RESULTS
Tank Size
—
gallons
Daily Flow
—
gallons/day
Field Area
—
sq ft
Trench Length
—
lin ft
Trench Layout
—
Gravel Needed
—
cu yards
Pipe Needed
—
lin ft
Estimated Cost
—
installed
Soil Loading Rate Reference
Soil Type
Perc Rate
Loading Rate
Notes
Gravel / Coarse Sand
<1 min/in
1.2 gal/sq ft/day
May need filter fabric
Sandy Loam
1–5 min/in
0.8 gal/sq ft/day
Excellent drainage
Loam / Silt Loam
6–30 min/in
0.5 gal/sq ft/day
Most common residential
Clay Loam
31–45 min/in
0.3 gal/sq ft/day
Larger field needed
Sandy Clay
46–60 min/in
0.2 gal/sq ft/day
Marginal performance
Heavy Clay
>60 min/in
Mound/ATU required
Conventional not suitable
⚠️ Septic system design requires a licensed engineer or sanitarian and local health department approval. Perc tests and soil evaluations must be performed on-site. This calculator is for planning and budgeting only, never install a septic system without a professional design and permits.
Enter your home's bedroom count, number of occupants, and soil type from your perc test to get tank size, drain field dimensions, and an installed cost estimate. Soil type is the single most important variable, clay soil can require a drain field 4–6× larger than the same home on sandy soil. This calculator is for planning and budgeting; a licensed septic designer must prepare the actual permitted design.
How to Size a Septic Tank
Most state codes size septic tanks by bedrooms: 1–2 bedrooms = 1,000 gallons minimum; 3 bedrooms = 1,000–1,250 gallons; 4 bedrooms = 1,250–1,500 gallons. The general rule requires the tank to hold 1.5–2 days of daily sewage flow. At 75 gallons per person per day, 4 occupants generate 300 gallons/day, requiring a 600-gallon minimum by flow, but code minimums of 1,000 gallons override this for small households. Always use the larger of the bedroom-based or flow-based requirement.
Septic System Type Comparison
System Type
Best For
Cost Premium
Maintenance
Conventional gravity
Good soil, adequate lot size
Baseline
Pump every 3–5 years
Chamber system
Limited space, good soil
+10–20%
Same as conventional
Mound system
High water table, shallow soil, poor perc
+$5,000–$10,000
Annual inspection recommended
Aerobic treatment unit (ATU)
Very poor soil, small lots, setback issues
+$5,000–$15,000
Annual maintenance contract required
Drip irrigation
Poor soil, very small lots
+$8,000–$20,000
Annual inspection + filter cleaning
Septic System Maintenance Schedule
Task
Frequency
Cost
Why It Matters
Pump septic tank
Every 3–5 years
$200–$500
Prevents sludge overflow into drain field
Inspect baffles and distribution box
Every 3–5 years (with pumping)
Included
Baffles fail; distribution box shifts
Inspect ATU / aerobic unit
Annually (most states require)
$150–$500/yr
Contractual requirement for ATU systems
Check for wet spots / odors
Seasonally
Free
Early warning of field failure
Drain field restoration treatment
If sluggish
$200–$1,000
Breaks up biomat before full failure
Common Septic System Mistakes
Not pumping on schedule. The most common cause of drain field failure is sludge and scum overflowing from an unpumped tank into the drain field. Once solids reach the field, they clog the soil and the field fails, at a replacement cost of $5,000–$30,000. Pumping every 3–5 years costs $200–$500. The math is obvious, but about half of septic tanks nationwide go more than 10 years between pumpings.
Planting trees or shrubs over the drain field. Tree roots seek moisture and will infiltrate drain field pipes within 5–10 years, crushing and clogging the system. Keep the drain field clear of all woody plants. Grass is ideal, it takes up moisture and keeps the field from compacting under traffic.
Driving over the drain field. Vehicle weight compacts the soil and crushes distribution pipes, both of which permanently reduce field capacity. Mark your drain field boundaries and keep vehicles, heavy equipment, and even riding mowers off the area.
Using garbage disposals heavily with a septic system. Garbage disposals add significant food solids to the tank, accelerating sludge accumulation. Homes with septic systems should use disposals sparingly or not at all, pump more frequently (every 2–3 years) if a disposal is used regularly.
Assuming a perc test result is permanent. A perc test result is a snapshot of soil conditions on the day of the test. Soil conditions change, drought hardens clay, development changes drainage patterns, and water table levels shift seasonally. Always get a fresh perc test for any new system design, even if a test was done on the property years ago.
Buying a home with a septic system: Always request the as-built drawing showing tank location, drain field boundaries, and system type before closing. Have the tank pumped and inspected by a licensed septic inspector as part of your due diligence, this costs $300–$600 and is the only way to know the system's actual condition. A failing drain field that looks fine from the surface can cost $15,000–$30,000 to replace. It's not a detail to skip.
Septic System Layout Diagram
A conventional septic system has three main components: the septic tank (for settling and anaerobic digestion), the distribution box (for even flow to the drain field), and the drain field (for soil absorption). Each must be properly sized for the home's daily flow and the site's soil conditions.
Tank size governed by bedrooms and daily flow · Drain field size governed by soil loading rate · Perc test required before design
Understanding the Percolation Test
The percolation test (perc test) is the foundational soil evaluation that determines whether a site can support a conventional septic system and, if so, how large the drain field must be. It must be performed by a licensed engineer or soil scientist in most states, and the results must accompany the permit application.
A perc test measures how quickly water absorbs into the soil. The test involves digging several holes to the proposed drain field depth, saturating the soil, and timing how long it takes for the water level to drop one inch. The result (in minutes per inch) determines the soil loading rate, how many gallons of effluent each square foot of drain field can absorb per day.
Perc Rate
Soil Type
Loading Rate
Drain Field for 3-BR Home
Under 1 min/in
Gravel / coarse sand
1.2 gal/sq ft/day
~250 sq ft (tiny, may need filter)
1–5 min/in
Sandy loam
0.8 gal/sq ft/day
~375 sq ft (excellent drainage)
6–30 min/in
Loam / silt loam
0.5 gal/sq ft/day
~600 sq ft (most common residential)
31–45 min/in
Clay loam
0.3 gal/sq ft/day
~1,000 sq ft (requires larger lot)
46–60 min/in
Sandy clay
0.2 gal/sq ft/day
~1,500 sq ft (marginal)
Over 60 min/in
Heavy clay
Not suitable
Mound, ATU, or community system required
Septic System Types, When Each Is Used
System Type
When Required
Cost Premium
Maintenance
Conventional gravity
Standard soils; adequate lot size; level to moderate slope
Baseline
Pump every 3–5 years
Chamber system
Same as gravity; allows smaller drain field footprint
10–15% more
Pump every 3–5 years
Mound system
High water table; shallow soil over rock; slow perc in upper soil
50–100% more
Pump annually; inspect mound
Aerobic treatment unit (ATU)
Failing perc; small lots; near water bodies; required in some states
100–200% more
Service contract required; quarterly inspection typical
Drip irrigation system
Difficult sites; environmentally sensitive areas
150–250% more
Service contract; filter replacement
Septic system design, permitting, and installation costs vary dramatically by state and county. For cost budgeting, see our project cost estimation guide.
Frequently Asked Questions
How big of a septic tank do I need for a 3-bedroom house? ▾
A 3-bedroom house requires a minimum 1,000-gallon septic tank in most states regardless of occupant count. With 4 occupants at 75 gallons/day = 300 gallons/day, the tank must hold 2 days of flow = 600 gallons minimum by flow calculation, but code requires 1,000 gallons as a hard minimum. For 5+ occupants, increase to 1,250 gallons. Always verify your specific state and county requirements, minimums vary from 750 to 1,500 gallons for the same bedroom count.
How much does a septic system cost? ▾
A conventional septic system for a 3-bedroom home costs $5,000–$15,000 installed in most US markets, depending on soil conditions, site access, and local labor rates. Mound systems add $5,000–$10,000 due to fill material and elevated construction. Aerobic treatment units cost $10,000–$20,000 and require annual maintenance contracts ($150–$500/year). Perc testing and design fees add $500–$2,000. In high-cost markets (CA, NY metro, HI), add 40–60% to these estimates.
How often does a septic tank need to be pumped? ▾
Every 3–5 years for a typical family of 4 with a 1,000-gallon tank. Smaller tanks or larger families may need pumping every 2–3 years. Signs it needs immediate attention: slow drains throughout the house, gurgling sounds in drains, sewage odors inside or near the tank, or wet spots over the drain field. Regular pumping ($200–$500) is the cheapest maintenance you'll do, ignoring it risks drain field failure at $10,000–$30,000 to replace.
What is a perc test and do I need one? ▾
A percolation (perc) test measures how fast water drains through your soil, expressed in minutes per inch. A licensed soil evaluator digs test holes to the proposed drain field depth, fills them with water, and times the drainage rate. Most jurisdictions require a perc test before issuing a septic permit, and many require a licensed engineer or sanitarian to conduct it. Results determine the drain field size and whether a conventional system is even feasible, clay soils that fail perc often require more expensive alternative systems.
How do I know if my drain field is failing? ▾
Early signs include slow drains throughout the house (not just one fixture), gurgling sounds after flushing, sewage odors near the drain field or inside the home, and unusually lush or green grass over the drain field area. Advanced failure shows wet or soggy ground over the field, sewage surfacing above ground, or sewage backing up into the house. If you notice any of these, stop using water-intensive fixtures and call a licensed septic contractor immediately, catching it early may allow field rehabilitation ($200–$1,000) rather than full replacement ($10,000–$30,000).